200-Piece 330027-100-24 Preformed PCB Jumper Wires 0.100-Inch 24 AWG
$24.95
Package of 200 preformed U-shaped through-hole PCB jumper wires identified by the original surplus container as part number 330027-100-24, JUMPER .100LS 24 AWG, Revision D.
These formed jumper wires are designed to create a permanent electrical bridge between two circuit-board points. The .100LS marking indicates approximately 0.100-inch or 2.54 mm lead spacing, and the wire is identified as 24 AWG. They are useful for circuit-board assembly, trace bridging, board modifications, prototyping, restoration work, and replacement of missing or damaged PCB jumpers.
These are bare formed-wire PCB jumpers and are not removable plastic header shunts. The original manufacturer, conductor material, plating composition, current rating, and voltage rating are not identified on the container.
Historical Note: Preformed through-hole jumper wires have long been used in commercial circuit-board manufacturing and repair to bridge circuit points, accommodate board-layout limitations, and implement production revisions without adding additional printed copper traces.
Quantity supplied is 200 pieces. Product photographs show the actual surplus stock and original container markings.
Compatible Radios / Boards
Suitable for through-hole printed circuit boards, prototyping boards, vintage electronics, radios, amplifiers, test equipment, control boards, and general electronic repair applications requiring a preformed 24 AWG jumper marked for approximately 0.100-inch lead spacing. Buyer must verify lead spacing, leg length, board-hole diameter, electrical requirements, and physical fit before installation.
RF Boneyard Bench Notes
Visually inspected unused surplus stock. Jumpers appear clean with no visible solder residue. Pieces have not been individually electrically tested. Conductor material, plating, current rating, voltage rating, and environmental compliance have not been independently verified.
Ask the bench before you buy.
Post a question about this part
Login or create an account to ask a product question. This helps keep spam out of the RF Boneyard bench.
Login to AskAnswered Questions
No answered questions yet. Be the first to ask the bench.