Nippon Chemi-Con SMH 1000µF 16V 85°C Radial Electrolytic Capacitor 10-Pack
$24.99
10-pack of Nippon Chemi-Con SMH 1000µF 16V radial electrolytic capacitors suitable for electronics repair, power supply filtering, audio equipment service, CB radio repair, ham radio bench stock, vintage electronics restoration, and general capacitor replacement inventory. These capacitors are marked 1000µF 16V with an 85°C temperature rating.
Historical Note:
Nippon Chemi-Con is one of Japan’s major electrolytic capacitor manufacturers and has supplied capacitors for consumer electronics, communications equipment, power supplies, industrial controls, audio gear, and test equipment. Large-value radial electrolytics such as 1000µF capacitors are commonly used for filtering, decoupling, ripple reduction, and power rail stabilization in repair and restoration work.
Origin Tracker
NOS / New Old Stock
Unused new old stock from legacy inventory. Packaging, age, and cosmetic condition may vary.
Pipeline quantities are informational and may change after arrival, inspection, sorting, testing, or donor teardown.
Compatible Radios / Boards
Suitable for power supply filtering, audio repair, CB radio repair, ham radio equipment service, vintage electronics restoration, bench replacement stock, capacitor kit building, amplifier repair, and general electronics troubleshooting where 1000µF 16V polarized radial electrolytic capacitors are required. Buyer should confirm capacitance, voltage rating, polarity, lead spacing, diameter, height, temperature rating, and circuit requirements before installation.
RF Boneyard Bench Notes
Tester / Method:
DER EE DE-5000 LCR meter
Sample Method:
Random sample capacitor pulled from lot and bench tested as supplied.
Bench Measurements:
Marked Value: 1000µF 16V
Measured Capacitance: 868µF
Test Frequency: Not recorded
ESR: Not recorded
Bench Evaluation:
PASS - Random sample capacitance measured 868µF against the marked 1000µF value.
PASS - Measured capacitance is approximately 13.2% below the marked 1000µF value.
PASS - Capacitance reading is within normal electrolytic capacitor tolerance range.
PASS - Suitable for repair stock, restoration inventory, bench replacement use, and electronics service work.
PASS - Additional pieces from the same lot are sold as matching stock but individually untested unless stated.
Ask the bench before you buy.
Post a question about this part
Login or create an account to ask a product question. This helps keep spam out of the RF Boneyard bench.
Login to AskAnswered Questions
No answered questions yet. Be the first to ask the bench.